Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]MIXer:HARMonic:BAND A|Q|U|V|E|W|F|D|G|Y|J
With BAND LOCK ON, this command sets the active band.
Example: ":MIX:HARM:BAND E"
Features: *RST value: U
SCPI: device-specific
Mode:
A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe:]MIXer:LOSS[:LOW]
This command sets the conversion loss of the mixer.
Example: ":MIX:LOSS -12DB"
Features: *RST value: 0 dB
SCPI: conforming
Mode:
A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe:]MIXer:LOSS:HIGH
With BAND LOCK ON, this command sets the conversion loss of the mixer for higher harmonics in
bands with two harmonics (band A: even harmonics, band Q: odd harmonics).
Example: ":MIX:LOSS:HIGH -14DB"
Features: *RST value: 0 dB
SCPI: device-specific
Mode:
A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe:]MIXer:LOSS:TABLe
This command sets a conversion loss table.
Parameter: := DOS file name
Example: ":MIX:LOSS:table ’mix_1’"
Features: *RST value: no table set
SCPI: device-specific
Mode:
A
The command is available only if the external mixer (option FSE-B21) is switched on.
:[SENSe:]MIXer:BIAS
This command sets the bias current.
Example: ":MIX:BIAS 7mA"
Features: *RST value: 0 A
SCPI: conforming
Mode:
A
The command is available only if the external mixer (option FSE-B21) is switched on.
1088.7531.12 6.139 E-15