Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Configuration/Setup
ESIB
Parity – Bit parity check
NONE no parity check (default setting)
EVEN even parity check
ODD odd parity check
PARITY
NONE
EVEN
ODD
IEC/IEEE-bus command
:SYSTem:COMM:SERial[:RECeive]:PARity[:TYPE]
EVEN| ODD| NONE
Stop bits – Number of stop bits
Available are 1 and 2. The default setting is 1 stop bit.
STOPBITS
1
2
IEC/IEEE-bus command
:SYSTem:COMMunicate:SERial[:RECeive]:SBITs 1|2
HW-Handshake – Hardware handshake protocol
The integrity of data transmission can be improved through the use of a
hardware handshake protocol which prevents uncontrolled transmission of
data and the resulting possible loss of data bytes. With the hardware
handshaking procedure, additional interface lines are used to transmit
acknowledge signals with which the data transmission can be controlled and,
if necessary, stopped until the receiver is ready to receive data again.
A prerequisite for handshaking is, however, that the interface lines (DTR and
RTS) are provided between the sender and receiver. For a simple, 3-wire
connection, this is not the case and a hardware handshake cannot be
realized.
Default setting is NONE.
HW-HANDSHAKE
None
DTR/RTS
IEC/IEEE-bus command
:SYSTem:COMM:SERial:CONTrol:DTR IBFull|OFF
:SYSTem:COMM:SERial:CONTrol:RTS IBFull|OFF
1088.7531.12 4.44 E-15