Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]CORRection:TSET[:STATe] ON | OFF
This command switches the selected transducer set on or off.
Example: ":CORR:TSET ON"
Features: *RST value: OFF
SCPI: device-specific
Modes:
R, A
Prior to this command, the command SENS:CORR:TSET:SEL must be sent.
:[SENSe:]CORRection:TSET:DELete
This command deletes the selected transducer set.
Example: ":CORR:TSET:DEL"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A
This command is an event and thus has no *RST value assigned.
Prior to this command, the command SENS:CORR:TSET:SEL must be sent.
:[SENSe:]CORRection:CVL:CATalog?
This command polls the names of all conversion-loss tables stored on the harddisk.
Syntax of output format:
,,
,,,,,,....,,
Example: ":CORR:CVL:CAT?"
Feature: *RST value: -
SCPI: device-specific
Mode:
A
This command is only valid in conjunction with option External Mixer Output, FSE-B21.
:[SENSe:]CORRection:CVL:SELect
This command selects the Conversion Loss Table designated with . If is
not available, a new Conversion Loss Table will be created.
Parameter: ::= Name of Conversion Loss Table as string data with
a maximum of 8 characters
Example: ":CORR:CVL:SEL ’LOSS_TAB’"
Features: *RST value: -
SCPI: device-specific
Mode:
A
This command must be sent prior to the subsequent commands used to change/activate the
Conversion Loss files. It is only valid in conjunction with option External Mixer Output, FSE-B21.
1088.7531.12 6.115 E-15