Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Switchover to Remote Control
Remote Control via RSIB Interface
Windows Environment
To access the measuring instruments via the RSIB interface the DLLs should be installed in the
corresponding directories:
•RSIB.DLL in Windows NT system directory or control application directory.
• RSIB32.DLL in Windows NT system32 directory or control application directory.
On the measuring instrument the DLL is already installed in the corresponding directory.
Unix Enviroment
In order to access the measuring equipment via the RSIB interface, copy the librsib.so.X.Y file to a
directory for which the control application has read rights. X.Y in the file name indicates the version
number of the library, for example 1.0 (for details see Chapter 8).
Remote Control
The control is performed with Visual C++ or Visual Basic programs. The local link to the internal
controller is established with the name ’@local. If a remote controller is used, the instrument IP address
is to be indicated here.
Via VisualBasic: internal controller: ud = RSDLLibfind (’@local’, ibsta, iberr, ibcntl)
remote controller: ud = RSDLLibfind (’82.1.1.200’, ibsta, iberr, ibcntl)
Return to Manual Operation
The return to manual operation can be performed via the front panel (LOCAL key) or the RSIB interface.
Manually:
½ Press the LOCAL key.
Note:
Before switchover, command processing must be completed as
otherwise switchover to remote control is effected immediately.
Via RSIB: ...
ud = RSDLLibloc (ud, ibsta, iberr, ibcntl);
...
1088.7531.12 5.5 E-16