Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
CALCulate Subsystem
:CALCulate:LIMit:UPPer:STATe ON | OFF
This command defines the selected limit line as upper limit line.
Example: ":CALC:LIM:UPPer:STAT ON"
Features: *RST value: OFF
SCPI: conforming
Modes:
R, A, VA
In analyzer and vector analyzer mode, the result of the limit check can be queried with
CALCulate:LIMit:FAIL?.
:CALCulate:LIMit:UPPer:OFFSet
This command defines an offset for the Y-axis of the selected relative upper limit line.
Example: ":CALC:LIM:UPP:OFFS 3dB"
Features: *RST value: 0
SCPI: device-specific
Modes:
A, VA
:CALCulate:LIMit:UPPer:MARGin
This command defines the margin of the selected upper limit line.
Example: ":CALC:LIM:UPP:MARG 10dB"
Features: *RST value: 0
SCPI: device-specific
Modes:
A, VA
:CALCulate:LIMit:UPPer:MODE RELative | ABSolute
This command selects the relative or absolute scaling for the Y-axis of the selected upper limit line.
Example: ":CALC:LIM:UPP:MODE REL"
Features: *RST value: ABSolute
SCPI: device-specific
Modes:
A, VA
:CALCulate:LIMit:UPPer:SHIFt
This command shifts a limit line, which has relative values for the Y-axis (levels or linear units such
as volt).
Example: ":CALC:LIM:UPP:SHIF 20dB"
Features: *RST value: --
SCPI: device-specific
Modes:
R, A, VA
This command is an event which is why it is not assigned an *RST value and has no query.
1088.7531.12 6.25 E-15