Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]CORRection:TRANsducer:CATalog?
This command reads out the names of all transducer factors stored on the harddisk.
Syntax of output format:
,,
,,,,,,....,,
Example: ":CORR:TRAN:CAT?"
Feature: *RST value: -
SCPI: device-specific
Mode:
R, A
:[SENSe:]CORRection:TRANsducer:ACTive?
This command reveals the active transducer factor. If no transducer factor is switched on, a void
string will be output.
Example: ":CORR:TRAN:ACT?"
Feature: *RST value: -
SCPI: device-specific
Mode:
R, A
:[SENSe:]CORRection:TRANsducer:SELect
This command selects the transducer factor designated by . If does not exist yet, a
new transducer factor is created.
Parameter: ::= Name of the transducer factor in string data form with a
maximum of 8 characters.
Example: ":CORR:TRAN:SEL ’FACTOR1’"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A
This command must be sent prior to the subsequent commands for modifying/activating transducer
factors.
:[SENSe:]CORRection:TRANsducer:UNIT
This command defines the unit of the transducer factor selected.
Parameter: ::= ’DB’ | ’DBM’ | ’DBMV’ | ’DBUV’ | ’DBUV/M’ | ’DBUA’
’DBUA/M’ | ’DBPW’ | ’DBPT’
Example: ":CORR:TRAN:UNIT ’DBUV’"
Features: *RST value: ’DB’
SCPI: device-specific
Modes:
R, A
Prior to this command, the command SENS:CORR:TRAN:SEL must be sent.
1088.7531.12 6.111 E-15