Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

CALCulate Subsystem
ESIB
CALCulate:UNIT Subsystem
The CALCulate:Unit subsystem defines the units for vector signal analyzer mode and power
measurements.
CALCulate
:X
:UNIT
:TIME
:UNIT
:ANGLe
:POWer
COMMAND PARAMETERS UNIT COMMENT
S | SYM
DEG | RAD
DBM | V | W | DB |
PCT | UNITLESS |
DBPW | WATT |
DBUV | DBMV | VOLT |
DBPT | DBUA | AMPere
DBUV_MHZ | DBMV_MHZ |
DBUA_MHZ | DBUV_M | DBUA_M |
DBUV_MMHZ | DBUA_MMHZ
Vector Signal Analysis
Vector Signal Analysis
:CALCulate:X:UNIT:TIME S | SYM
This command selects seconds or symbols as an x-axis unit.
Example: ":CALC:X:UNIT:TIME S"
Features: *RST value: S
SCPI: device-specific
Mode:
VA-D
:CALCulate: UNIT:ANGLe DEG | RAD
This command selects the unit for angular measurement.
Example: ":CALC:UNIT:ANGL DEG"
Features: *RST- value: RAD
SCPI: device-specific
Mode:
VA-D
:CALCulate: UNIT:POWer DBM | V | W | DB | PCT | DBPT | UNITLESS | DBPW | WATT |
DBUV |DBMV | VOLT | DBUA | AMPere | DBUV_MHZ |DBMV_MHZ|
DBUA_MHZ | DBUV_M | DBUA_M |DBUV_MMHZ | DBUA_MMHZ
This command selects the unit for power.
Example: ":CALC:UNIT:POW DBM"
Features: *RST value: _
SCPI: device-specific
Modes:
R, A, VA
In the receiver mode, the units DBM, DBUV, DBPT, DBUA, DBPW, DBT, DBUV_M and DBUA_M
are available. In the analyzer mode, all unit are available except for DBPT, DEG, RAD, S, and HZ.
The units DEG, RAD, S, and HZ are available only in the vector analyzer mode.
DBUV_MHZ and DBUA_MHZ denote the units DBUV/MHZ or DBUA/MHZ.
1088.7531.12 6.58 E-15