Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

SENSe Subsystem
ESIB
SENSe:DETector Subsystem
The SENSe:DETector subsystem controls the recording of measurement values via the type of detector
selected for each trace.
The suffix in SENSe is not significant in this subsystem.
[SENSe]
:DETector
[:FUNCtion]
COMMAND PARAMETERS UNIT COMMENT
:AUTO
:RECeiver
[:FUNCtion]
:FMEasurement
APEak | NEGative| POSitive | SAMPle| RMS
| AVERage | QPEak | ACVideo
POSitive | NEGative | RMS | AVERage |
QPEak | ACVideo, POSitive | NEGative|
RMS | AVERage | QPEak | ACVideo
POSitive | NEGative | RMS | AVERage |
QPEak | ACVideo
--
ACVideo only with option
ESIB-B1
:[SENSe:]DETector[:FUNCtion] APEak | NEGative | POSitive| SAMPle | RMS |
AVERage | QPEak
This command switches the detector for recording of the measured value.
Example: ":DET POS"
Features: *RST value: Trace1: POSitive
Trace 2: AVERage
SCPI: conforming
Modes:
R, A
In scan mode of the receiver, the detectors POSitive, RMS, AVERage, QPEak and ACVideo are
available (ACVideo only with option ESIB-B1).
In the analyzer mode, the detectors APEak, POSitive, NEGative, RMS, SAMPLe and AVERage are
available. The value "APEak" (AutoPeak) displays both the positive peak value and the negative
peak value when noise is present. The positive peak value is displayed when one signal is present.
The trace is selected by means of the numeric suffix after DETector.
:[SENSe:]DETector[:FUNCtion]:AUTO ON | OFF
This command either couples the detector to the current trace setting or turns coupling off.
Example: ":DET:AUTO OFF"
Features: *RST value: ON
SCPI: conforming
Mode:
A
The trace is defined by the numeric suffix at DETector.
1088.7531.12 6.120 E-15