Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
INITiate Subsystem
INITiate Subsystem
The INITiate subsystem checks the initialization of the trigger subsystem.
In receiver mode, a distinction is made between single measurement (INITiate1) and scan (INITiate2).
In signal analyzer mode, a distinction is made between INITiate1 (screen A) and INITiate2 (screen B) in
split screen representation.
INITiate
:CONTinuous
:CONMeas
[:IMMediate]
:DISPlay
COMMAND PARAMETERS UNIT COMMENT
--
--
--
--
--
--
no query
no query
:INITiate:CONTinuous ON | OFF
This command determines if the trigger system is continuously initiated ("Free Run").
Example: ":INIT:CONT OFF"
Features: *RST value: ON
SCPI: conforming
Modes:
R, A, VA
Setting "INITiate:CONTinuous ON" corresponds to function SCAN/SWEEP CONTinuous, ie the
scan/sweep of the receiver/analyzer is cyclically repeated. The setting "INITiate:CONTinuous
OFF" corresponds to function SCAN/SWEEP SINGLE.
:INITiate:CONMeas
This command continues the sweep from the current sweep position.
Example: ":INIT:CONM"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A, VA
This command is an event and therefore has no *RST value and no query.
Sweeps are stopped, for example, in the case of transducer sets between the different transducer
factors.
:INITiate[:IMMediate]
The command initiates a new sweep/scan or starts a single sweep/scan.
Example: "INIT"
Features: *RST value: -
SCPI: conforming
Modes:
R, A, VA
This command is an event which is why it is not assigned an *RST value and has no query.
:INITiate:DISPlay ON | OFF
This command switches the display on or off during a single sweep.
Example: ":INIT:DISP OFF"
Features: *RST value: ON
SCPI: device-specific
Modes:
R, A, VA
1088.7531.12 6.81 E-15