Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

TRIGger Subsystem
ESIB
:TRIGger[:SEQuence]:LEVel:AF
This command defines the level of the demodulated trigger source.
The units and ranges are:
AM-Demod -120 PCT to +120 PCT (PCT)
FM-Demod -1kHz to +1kHz (Hz)
PM-Demod -12 to + 12 RAD (DEG or RAD)
Example: ":TRIG:LEV:AF 50PCT"
Features: *RST value: 0 PCT
SCPI: device specific
Mode:
VA-A
:TRIGger[:SEQuence]:HOLDoff -100s to 100s
This command defines the length of the trigger delay.
Example: ":TRIG:HOLD 500us"
Features: *RST value: 0s
SCPI: conforming
Modes:
R, A, VA
A negative delay time (pretrigger) can be set in the time domain (SPAN < 0 Hz) only. The maximum
permissible range and the maximum effective resolution of the pretrigger are limited by the set
sweep time (max range= - 499/500 x sweep time; max. resolution = sweep time/500). Pretriggering
is not possible when the rms or the average detector is activated.
:TRIGger[:SEQuence]:SLOPe POSitive | NEGative
This command selects the slope of the trigger signal.
Example: ":TRIG:SLOP NEG"
Features: *RST value: POSitive
SCPI: conforming
Modes:
R, A, VA
The selected trigger slope applies to all trigger signal sources.
1088.7531.12 6.178 E-15