Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]SWEep:GAP:PRETrigger 0 to 100s
This command defines the evaluation time for measured values before the pretrigger time
(resolution: 50 ns).
Example: ":SWE:GAP:PRET 100us"
Features: *RST value: 0s
SCPI: device-specific
Mode:
A
:[SENSe:]SWEep:GAP:TRGTogap 0 to 100s
This command defines the time between the pretrigger time and the beginning of the gap (trigger-togap
time) (resolution: 50 ns).
Example: ":SWE:GAP:TRGT 50us"
Features: *RST value: 0s
SCPI: device-specific
Mode:
A
:[SENSe:]SWEep:GAP:LENGth 0 to 100s
This command defines the gap length.
Example: ":SWE:GAP:LENG 400us"
Features: *RST value: 0s
SCPI: device-specific
Mode:
A
The gap length can be programmed from 0 to 100s in steps of 1, 2, 3 and 5.
:[SENSe:]SWEep:SPACing LINear | LOGarithmic | AUTO
This command toggles between linear and logarithmic step modes of the receiver. In analyzer mode,
it toggles between linear and logarithmic sweep.
Example: ":SWE:SPAC LOG"
Features: *RST value: LIN
SCPI: conforming
Modes:
R, A
The frequency axis is set to linear or logarithmic scaling accordingly.
1088.7531.12 6.153 E-15