Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Configuration/Setup
Serial Interface Configuration
CONFIGURATION SETUP-GENERAL SETUP submenu:
COM
PORT 1
COM
PORT 2
The COM PORT 1 and COM PORT 2 softkeys activate the columns COM1
and COM2, respectively, for entry of the serial interface parameters Since the
two interfaces are configured in the same manner, how to configure an
interface is described in the following using COM PORT 1.
The following parameters must be in the table:
Baud rate
data transmission rate
Bits
number of data bits
Parity
bit parity check
Stop bits
number of stop bits
HW-Handshake hardware handshake protocol
SW-Handshake software handshake protocol
Owner
assignment of the serial port to the ESIB or computer
COM PORTS
Baud
Bits
Parity
Stopbits
HW-Handshake
SW-Handshake
Owner
COM 1
9600
8
None
1
None
XON/XOFF
Instrument
COM 2
1200
8
None
1
None
None
Instrument
Note:
A serial interface (COM1 or COM2) cannot be used for another
purpose if a mouse is connected to it.
Baud – Data transmission rate
Allowed are the indicated values between 110 and 19200 baud. The default
setting is 9600 baud.
BAUD RATE
19200
9600
4800
1200
600
300
110
IEC/IEEE-bus command
:SYSTem:COMMunicate:SERial[:RECeive]:BAUD 9600
Bits – Number of data bits per word
For the text transmission without special characters, 7 bits are adequate. For
binary data as well as text with special characters, 8 bits must be selected
(default setting).
BITS
7
8
IEC/IEEE-bus command
:SYSTem:COMMunicate:SERial[:RECeive]:BITS 7 | 8
1088.7531.12 4.43 E-15