Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Options
ESIB
Installing a user
After the network software has been installed, the instrument logs with an error message during the next
start-up since there is no user "Instrument" (= user identification for NT autologin) in the network. It is
therefore necessary to install a user which should be the same for Windows NT and for the network.
The network administrator is responsible for the installation of new users in the network.
Note:
The installation of new users is possible only under the administrator identification (see
section "Controller Function").
½ Click "Start" in the task bar.
½ Click consecutively "Programs"
"Administrative Tools (Common)" and
"User Manager" .
The "User Manager" menu is opened.
½ Click "User" and select "New User".
The menu "New User" for entering user
data is opened.
½ Fill in the lines "Username", "Password"
and "Confirm Password" and confirm
the entry with OK.
The user data should correspond to the
network settings.
1088.7531.12 1.48 E-3