Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Calibration
Results of System Error Correction
SYSTEM CAL menu:
CAL
RESULTS
The CAL RESULTS softkey in the right-hand supplementary menu calls the
CALIBRATION RESULTS table, which displays the correction data that has
been recorded.
The CALIBRATION RESULTS table contains the following information:
page 1:
• date and time of the last recorded correction values
• overall results of the correction value recording
• list of the correction procedures according to function/module, including the
correction values, the measured results and the individual results for each
of the correction procedures
The results for the individual correction procedures are categorised and
displayed as follows:
PASSED system error correction was completely successful
CHECK deviations larger than expected, however, corrections could
be performed
FAILED deviations too large, no corrections were possible
ABORTED correction aborted
CALIBRATION RESULTS
CALIBRATION: PASSED
Last cal total: 05.Jun 1997 16:24:54
Calibration of IF Filters PASSED
IF GAIN Adjust
PASSED
Bandwidth:
Filter Cal Val [Hz] DAC Val State
1kHz 2.806e+01 1679 PASSED
2kHz 1.603e+01 2887 PASSED
3kHz -6.012e+00 3238 PASSED
5kHz -1.002e+01 3514 PASSED
10kHz 1.804e+02 3703 PASSED
20kHz 3.607e+02 3801 PASSED
30kHz 8.417e+02 3831 PASSED
50kHz 1.403e+03 3743 PASSED
100kHz 1.804e+03 3698 PASSED
200kHz 3.607e+03 3606 PASSED
300kHz 8.417e+03 3516 PASSED
500kHz 1.403e+04 3329 PASSED
1MHz 2.806e+04 2881 PASSED
IEC/IEEE- bus command --
PAGE UP
The PAGE UP and PAGE DOWN softkeys can be used to page through the
table of correction results.
PAGE DOWN
1088.7531.12 4.13 E-15