Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Configuration/Setup
Fig. 4-3
Logarithmic frequency axis and logarithmic interpolation
Fig. 4-4
Logarithmic frequency axis and linear interpolation
Comment - Entry of a comment
The comment can be freely selected. It can have a maximum number of 50
characters.
IEC/IEEE-bus command :[SENS:]CORR:TRAN:COMM
TRD FACTOR
VALUES
INSERT
LINE
DELETE
LINE
The TRD FACTOR VALUES softkey activates the entry for the reference
values of the transducer factor.
The selection bar marks the first reference value. The desired reference
values have to be entered in ascending frequency sequence.
After entering the frequency the selection bar automatically jumps to the
corresponding level value. After entering the first reference value the table
can be edited. The two INSERT LINE and DELETE LINE softkeys are
displayed. Individual values are changed at a later time by marking the field
and by entering the new value.
IEC/IEEE-bus command :[SENS:]CORR:TRAN:DATA
,
The INSERT LINE softkey inserts a free line above the marked reference
value. When entering a new reference value into this line watch out for the
ascending frequency sequence.
The DELETE LINE softkey deletes the marked reference value (the whole
line). The following reference values move up.
IEC/IEEE-bus command --
SAVE TRD
FACTOR
The SAVE TRD FACTOR softkey saves the changed table in a file on the
internal hard disk.
If a transducer factor with the same name already exists, a corresponding
query is performed beforehand.
If the factor to be newly saved is currently switched on, the new values will
immediately be valid. If a transducer set is switched on comprising the factor,
the values will only be used when the set is switched on next time.
IEC/IEEE-bus command - (executed automatically)
1088.7531.12 4.27 E-15