Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

I
Start-Up
ESIB
AC power switch on the rear panel
ON
OFF
0
Ac power switch
Fuse holder
AC power connector
Power switch
After turn-on (position ON), the instrument is in the ready
state (STANDBY) or in operation dependent upon the
position of the ON/STANDBY switch located on the
instrument front panel (see below).
Note: The AC power switch can be left ON all the time..
Switching to OFF is only required when the instrument
has to be completely disconnected from the AC power
source.
Switching to OFF (position OFF) disconnects the ESIB
completely from the AC power source.
ON/STANDBY switch on the front panel
ON
STANDBY
.
Standby
½ ON/STANDBY switch is not depressed.
The yellow LED (STANDBY) is on. Only the ESIB‘s
internal power is connected to the AC line. The crystal
oven is maintained at the normal operating temperature.
Operation
Caution:
In standby mode, the ESIB is
still live.
½ ON/STANDBY is depressed.
The green LED (ON) is on. The instrument is ready for
operation. All modules within the instrument are supplied
with power.
Switching on the Instrument
½ To switch on the ESIB, set the power switch on the rear panel to position I.
½ Pressing the ON/STANDBY key on the front panel. The green LED ahould come on.
Startup Menu and Booting
When the instrument is switched on, a message indicating the installed BIOS version (eg Analyzer BIOS
Rev. 1.2) appears on the screen for a few seconds.
Windows NT is booted first and then the instrument firmware. As soon as boot up is over, the instrument
will start measuring. The settings used will be the one that was active when the instrument was
previously switched off, provided no other device configuration than FACTORY had been selected with
AUTO RECALL in the MEMORY menu.
Switching off the Instrument
½ Remove the disk, if any, from the drive before switching off.
½ Press the ON/STANDBY key on the front panel. The yellow LED should come on.
Only when completely disconnecting the ESIB from the AC power source:
½ Set the power switch on the rear panel to position 0.
1088.7531.12 1.20 E-3