Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]SWEep:TIME:FMEasurement :
This command defines the measurement time in which the values indicated in the peak list (final
measurement values) are re-checked.
Example: "SWE:TIME:FME 0.01"
Features: *RST value: 1s
SCPI: device specific
Mode:
R
:[SENSe:]SWEep:COUNt 0 to 32767
This command defines the number of sweeps started with single sweep.
Example: ":SWE:COUNT 64"
Features: *RST value: 0
SCPI: conforming
Modes:
R, A, VA-D
This parameter defines the number of sweeps or the number of averaging procedures. In the
average mode, the value 0 defines a running averaging of measurement data over 10 sweeps.
:[SENSe:]SWEep:EGATe ON | OFF
This command controls the sweep with the external gate signal.
Example: ":SWE:EGAT ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
A
:[SENSe:]SWEep:EGATe:LEVel -5V to +5V
This command determines the threshold for the external gate signal.
Example: ":SWE:EGAT:LEV 3V"
Features: *RST value: 2V
SCPI: device-specific
Mode:
A
If SWEep:TIME is directly programmed, automatic coupling is switched off.
:[SENSe:]SWEep:EGATe:TYPE LEVel | EDGE
This command sets the type of triggering (level or edge) by the external gate signal.
Example: ":SWE:EGAT:TYPE EDGE"
Features: *RST value: EDGE
SCPI: device-specific
Mode:
A
Parameter EGATe:LENGth is not used for level triggering.
1088.7531.12 6.151 E-15