Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Sweep Control - Analyzer
ESIB
SWEEPTIME
AUTO
SWEEPTIME
MANUAL
The SWEEPTIME AUTO and SWEEPTIME MANUAL softkeys activate the
automatic or manual selection of the sweep time. These functions are
identical to the entries in the COUPLING menu (see section "Setting and
Coupling the Coupling Resolution, Video Bandwidth and Sweep Time").
IEC/IEEE-bus commands
:[SENSe:]SWEep:TIME:AUTO ON | OFF
:[SENSe:]SWEep:TIME 10s
SGL SWEEP
DISP OFF
The SGL SWEEP DISP OFF softkey switches off the display during a single
sweep. The trace is displayed when the sweep has been completed.
IEC/IEEE-bus commands
:INITiate:DISPlay ON | OFF;
:INITiate
SWEEP
COUNT
The SWEEP COUNT softkey activates the entry of the number of sweeps
performed by the ESIB after the start of a single sweep. If trace average, max
hold or min hold is switched on, this also determines the number of averages
or minimua/maxima that are taken.
Example:
[TRACE1: MAX HOLD]
[SWEEP: SWEEP COUNT: {10} ENTER]
[SINGLE SWEEP]
The ESIB performs the max hold function over 10 sweeps.
The sweep count range is 0 through 32767. For sweep count = 0 or 1, a
sweep is performed. For trace averaging (AVERAGE), sweep count = 0 and
continuous sweep, the ESIB performs a sliding average over 10 sweeps in
average mode. For sweep count = 1, no averaging takes place.
The default setting totals 10 sweeps.
Note: The setting for the number of sweeps in the TRACE menu is
equivalent to the setting in the SWEEP menu. In SINGLE SWEEP
mode, the measurement is stopped after reaching the chosen
number of sweeps.
IEC/IEEE-bus command :[SENSe:]SWEep:COUNt 0
1088.7531.12 4.252 E-15