Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Tracking generator - Transmission measurement
Transmission Measurement
In this measurement, the transmission characteristic of a two-port network is measured. The built-in
tracking generator is the a signal source. The tracking generator is connected to the input of the DUT.
The input of the instrument is connected to the output of the DUT.
GEN OUTPUT
RF INPUT
DUT
Fig. 4-20 Test setup for reflection measurements
Calibration can be carried out to allow for the effects from the test setup (eg. frequency response of
connecting cables).
Calibration of the Transmission Measurement
SYSTEM MODE-TRACKING GENERATOR menu:
SOURCE
CAL
SOURCE
CAL
CAL
TRANS
CAL REFL
SHORT
CAL REFL
OPEN
REF VALUE
POSITION
The SOURCE CAL softkey opens a submenu with the
calibration functions for transmission and reflection
measurements.
The calibration for the reflection measurement is described
of the following sections .
To carrry out a calibration for transmission measurements
the whole test setup is through-connected (THRU).
REF VALUE
NORMALIZE
RECALL
1088.7531.12 4.265 E-15