Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Front View
1 Preparing for Operation
Chapter 1 describes the controls and connectors of the EMI Test Receiver ESIB by means of the front
and rear view. Then follows all the information that is necessary to put the instrument into operation and
connect it to the AC supply and to external devices.
A more detailed description of the hardware connectors and interfaces can be found in chapter 8.
Chapter 2 provides an introduction into the operation of the ESIB by means of typical examples of
configuration and measurement; for the description of the concept for manual operation and an
overview of menus refer to chapter 3. For a systematic explanation of all menus, functions and
parameters and background information refer to the reference part in chapter 4. For remote control of
the ESIB refer to the general description of the SCPI commands, the instrument model, the status
reporting system, and command description in chapter 5 and 6.
Description of Front and Rear Panel Views
Front View
1
Display Screen see Chap. 3 and 4
2
Softkeys see Chap. 3 and 4
3 USER
USER Generate macros see Chap. 4
4 MARKER
MARKER
NORMAL SEARCH
DELTA MKR
Select and set marker
NORMAL Select and set the marker
SEARCH Set and start the peak/min search
DELTA Select and set the delta markers
MKR ⇒ Set the active marker
see Chap. 4
5 FREQUENCY
FREQUENCY
CENTER / SPAN /
FREQ ZOOM
START STOP
Define frequency axis in the active window
CENTER/ Set center frequency etc.
FREQ Set receiver frequency
SPAN/ Set sweep span
ZOOM Set zoom frequencies
START Set start frequency
STOP Set stop frequency
see Chap. 4
1088.7531.12 1.1 E-3