Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Start-Up
19" Rack Installation
Important Note:
When the instrument is rack-mounted, ensure that the air flow through the sidepanel
holes and the air outlet in the rear panel are not obstructed.
The instrument may be mounted in a 19" rack by using the rack adapter kit ZZA-95 (order number: see
data sheet). The installation instructions are included in the adapter kit.
EMI Protection Measures
In order to prevent electromagnetic interference (EMI), the instrument may be operated only when all
covers are correctly in place. Only adequately shielded signal and control cables may be used (see
recommended accessories).
Connecting to AC Supply
The ESIB features automatic AC-line voltage selection (range: see power supply name-plate). The AC
power connector is located on the rear panel (see below).
½ Connect the instrument to the AC power source using the AC power cable delivered with the
instrument.
AC Power Line Fuses
The ESIB is protected by two fuses as specified on the power supply name-plate. The fuses are located
in a removable fuse holder which is located between the AC power switch and the AC power connector
(see below).
Switching the Instrument on/off
Caution:
Do not power down during booting. This may corrupt harddisk files.
Note: On power-up, the drive should contain no disk, since otherwise the instrument will try to boot from
the disk.
1088.7531.12 1.19 E-3