Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB Command Assignment - General Device Settings
Basic Instrument - General Device Settings
DATA VARIATION Key Group
HOLD
UNLOCK
no corresponding IEC/IEEE-bus command
LOCK DATA
no corresponding IEC/IEEE-bus command
LOCK ALL
no corresponding IEC/IEEE-bus command
STEP
if needed, the step width is entered in the subsystem of the corresponding parameter.
STEPSIZE
AUTO
--
STEPSIZE
MANUAL
--
SYSTEM Key Group
DISPLAY
FULL SCREEN
DISPlay:FORMat SINGle
SPLIT
SCREEN
ACTIVE
SCREEN x
SCREEN A
BARGRAPH
SCREEN A
SWEEP
RUN
SCAN
SCREEN
COUPLING
MODE
COUPLED
HORIZONTAL
SCALING
VERTICAL
SCALING
COUPLING
CONTROL
DISPlay:FORMat SPLit
The screen is selected via the numeric suffix of the individual commands.
:INSTrument[1][:SELect] RECeiver
The softkey is available only in receiver mode
:INSTrument[1][:SELect] SANalyzer
The softkey is available only in receiver mode
The softkey is available only in receiver mode (see COUPLING/RUN)
--
:INSTrument:COUPle MODE
:INSTrument:COUPle X
:INSTrument:COUPle Y
:INSTrument:COUPle CONTrol
1088.7531.12 6.219 E-15