Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]FILTer:LPASs:FREQuency
This command defines the frequency limit of the low-pass filter in the NF-branch for analog
demodulation.
Parameter: ::= 3 kHz | 15 kHz for REAL TIME ON
5 PCT | 10 PCT | 25 PCT for REAL TIME OFF
Example: ":FILT:LPAS:FREQ 3KHZ" for REAL TIME ON
":FILT:LPAS:FREQ 25PCT" for REAL TIME OFF
Features: *RST value: - (STATe = OFF)
SCPI: conforming
Mode:
VA-A
:[SENSe:]FILTer:CCITt[:STATe] ON | OFF
This command activates the weighting filter according to CCITT-recommendation in the AF-branch
for analog demodulation.
Example: ":FILT:CCIT ON"
Features: *RST value: OFF
SCPI: conforming
Mode:
VA-A
This command is valid only in vector analysis mode with REAL TIME OFF.
:[SENSe:]FILTer:CMESsage[:STATe] ON | OFF
This command activates the C-message weighting filter according to CCITT-recommendation in the
AF-branch for analog demodulation.
Example: ":FILT:CMES ON"
Features: *RST value: OFF
SCPI: conforming
Mode:
VA-A
This command is valid only in vector analysis mode with REAL TIME OFF.
:[SENSe:]FILTer:DEMPhasis[:STATe] ON | OFF
This command activates the selected de-emphasis for analog demodulation.
Example: ":FILT:DEMP ON"
Features: *RST value: OFF
SCPI: conforming
Mode:
VA-A
1088.7531.12 6.131 E-15