Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Display Configuration
EMI RECEIVER mode:
In the RECEIVER mode, a selection can be made in the upper half of the screen (SCREEN A) between
bargraph display of the receiver mode and the spectrum analyzer mode.
With spectrum analyzer selected, the scan display in the lower half of the screen remains unchanged
and the spectrum analyzer with all its measurement functions is available in the upper screen half.
It is therefore possible to perform first a premeasurement with a scan and then to further investigate
suspect signals with the aid of the spectrum analyzer, eg in the zero span to determine time
characteristics. The center frequency of the spectrum analyzer can be coupled to the marker frequency
of the scan display so that the frequencies to be analyzed can be easily displayed in the spectrum
analyzer.
ACTIVE
SCREEN A
ACTIVE
SCREEN B
If SPLIT SCREEN display is activated, the ACTIVE SCREEN A and ACTIVE
SCREEN B softkeys activate either screen A or screen B.
The entry of new settings is only possible for the active window.
When switching back to FULL SCREEN mode, the active measurement
window is displayed.
These softkeys are only displayed if operation with two independent channels
and different softkey menus - receiver with scan display and spectrum
analyzer - is selected (SCREEN A SWEEP). Only in this case will it be
necessary to assign entries to the receiver or to the spectrum analyzer.
IEC/IEEE bus command - (the screen is selected via the numeric suffix)
SCREEN A
BARGRAPH
The SCREEN A BARGRAPH softkey switches on the bargraph display in the
upper half of the screen (SCREEN A).
IEC/IEEE bus command :INSTrument[1][:SELect] RECeiver
SCREEN A
SWEEP
The SCREEN A SWEEP softkey switches on the analyzer mode in the upper
half of the screen (SCREEN A).
The softkeys of all menus are assigned the analyzer functions. An exception
is the DISPLAY menu where the SCREEN A BARGRAPH softkey is
displayed to allow a return to the bargraph display of the receiver mode.
IEC/IEEE bus command :INSTrument[1][:SELect] SANalyzer
RUN SCAN
The RUN SCAN softkey starts the frequency scan with the selected settings.
(see Section "Frequency Scan").
ANALYZER mode:
ACTIVE
SCREEN A
ACTIVE
SCREEN B
If SPLIT SCREEN display is activated, the ACTIVE SCREEN A and ACTIVE
SCREEN B softkeys activate either screen A or screen B.
The entry of new settings is only possible for the active window.
When switching back to FULL SCREEN mode, the active measurement
window is displayed.
If, in addition, the two screens are both subdivided into two diagrams, the
ACTIVE SCREEN A/B softkeys activate the upper diagram, ACTIVE
SCREEN C/D the lower diagram in each screen.
IEC/IEEE- bus command - (the screen is selected via the numeric suffix)
1088.7531.12 4.5 E-15