Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Traces - Receiver
ESIB
TRACE 1 menu
TRACE
1 2
TRACE 1
CLEAR/
WRITE
VIEW
TRACE 1
T1-T2+REF
->T1
T1-T3+REF
->T1
3
3
4
BLANK
T1-T4+REF
->T1
T1-REF
->T1
MAX HOLD
MIN HOLD
ASCII
EXPORT
Traces 3 and 4 only
FINAL
RESULTS
SCAN
COUNT
ASCII
CONFIG
DETECTOR
COPY
TRACE MATH
OFF
The TRACE keys 1...4 call a menu which presents the setting options for the selected trace.
This menu is used to determine how the measured data will be represented in the frequency domain
using the 500 pixels provided by the display.
When the measurement is started, a new trace can be displayed or the trace can be based on previous
results.
Traces can be displayed, blanked and copied. By applying mathematical functions, the traces can also
be corrected. The measurement detector for each of the display types may be chosen directly by the
ESIB.
All activated traces are marked with a LED at the corresponding key (here, TRACE 1). The default
setting is TRACE 1 with CLEAR / WRITE and the PEAK detector selected, TRACE2 with CLEAR /
WRITE and the AVERAGE detector selected . The remaining traces 3 to 4 are switched off (BLANK).
The CLEAR/WRITE, MAX HOLD, MIN HOLD, VIEW, and BLANK are mutually exclusive selection
switches.
CLEAR/
WRITE
The CLEAR/WRITE softkey activates the clear/write display mode.
The trace is displayed without additional trace evaluation. The trace memory
is overwritten by each scan. If more than one data point falls within a pixel,
the trace is displayed in bar form with the maximum and minimum values in a
pixel connected. In the clear/write display mode, all the available detectors
are selectable.
Whenever the CLEAR/WRITE softkey is pressed, the ESIB clears the
selected trace memory and restarts the measurement.
IEC\IEEE bus command
:DISPlay[:WINDow]:TRACe:MODE WRITe
1088.7531.12 4.144 E-15