Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]BANDwidth|BWIDth[:RESolution]:MODE ANALog | DIGital
This command toggles between analog and digital resolution filters for the 1-kHz bandwidth.
Example: ":BAND:MODE DIG"
Features: *RST value: ANALog
SCPI: device-specific
Mode:
A
Depending on the bandwidth, the resolution filters are automatically toggled between digital filters
(1kHz). The 1-kHz bandwidth is present in the instrument as a digital
filter and as an analog filter and can be toggled using this command. If the analog filter is selected for
the bandwidth 1kHz, the FFT-filtering for bandwidths ≤ 1kHz is switched off.
:[SENSe:]BANDwidth|BWIDth[:RESolution]:MODE:FFT ON | OFF
This command toggles the digital filters used for bandwidths ≤ 1 kHz between ordinary mode and
FFT-filter mode.
Example: ":BAND:MODE:FFT ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
A
The filter bandwidth of 1 kHz is switched to digital filtering for both ON and OFF.
:[SENSe:]BANDwidth|BWIDth[:RESolution]:RATio 0.0001 to 1
This command defines the ratio resolution bandwidth (Hz) / span (Hz).
Example: ":BAND:RAT 0.1"
Features: *RST value: -- (AUTO is set to ON)
SCPI: conforming
Modes:
A, VA, R
The ratio to be entered is reciprocal to the ratio Span/RBW used in manual control.
:[SENSe:]BANDwidth|BWIDth[:RESolution]:FILTer 3dB | 6dB
In analyzer mode, this command switches between 3 dB and 6 dB bandwidths of the resolution
filters.
Example: "SENS:BWID:RES:FILT 6 dB"
Features: *RST value: 3 dB
SCPI: device-specific
Mode:
A
1088.7531.12 6.107 E-15