Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

CALCulate Subsystem
ESIB
:CALCulate:LIMit:ACPower:ALTernate 0 to 100DB, 0 to 100 dB.
This command defines the limit for the first/second alternate adjacent channel for adjacent channel
power measurements.
Parameter: The first (second) numeric value is the limit for the lower (upper) alternate
adjacent channel. The numeric suffix after ALTernate denotes the first
or the second alternate channel.
Examples: ":CALC:LIM:ACP:ALT2 30DB 30DB"
Features: *RST value: 0DB
SCPI: device-specific
Modes:
A, VA
The numeric suffixes or are not significant for this command.
:CALCulate:LIMit:ACPower:ALTernate:STATe ON | OFF
This command activates the limit check for the first/second alternate adjacent channel for adjacent
channel power measurements. Before, the limit check must be activated using CALC:LIM:ACP ON.
Examples: ":CALC:LIM:ACP:ALT2:STAT ON"
Features: *RST value: OFF
SCPI: device-specific
Modes:
A, VA
The numeric suffixes or are not significant for this command.
:CALCulate:LIMit:ACPower:ALTernate:RESult?
This command queries the result of the limit check for the first/second alternate adjacent channel for
adjacent channel power measurements.
Parameter: The result is returned in the form , where
= PASSED | FAILED and where the first (second) returned value
denotes the lower (upper) alternate adjacent channel.
Examples: ":CALC:LIM:ACP:ALT2:RES?"
Features: *RST value: --
SCPI: device-specific
Modes:
A, VA
This command is a query and therefore not assigned a *RST value. If the power measurement of the
adjacent channel is switched off, the command triggers a query error.
The numeric suffixes or are not significant for this command.
1088.7531.12 6.30 E-15