Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Analyzer - Search Functions
MARKER SEARCH menu
SUMMARY
MARKER
SUMMARY
MARKER
The SUMMARY MARKER softkey calls up the submenu for
selecting the summary marker measurements.
The softkey is only available in the time domain.
RMS
MEAN
PEAK HOLD
ON OFF
AVERAGE
ON OFF
SWEEP
COUNT
ALL SUM
MKR OFF
RMS
MEAN
The RMS softkey selects the measurement of the rms value of the signal per
sweep.
In case of maximum peak evaluation the highest rms value since the activation of
PEAK HOLD ON is displayed. In case of AVERAGE ON the rms values of a trace
are averaged and displayed over several sweeps.
The number of sweeps is set with the SWEEP COUNT softkey. If PEAK HOLD =
ON is active at the same time, the display is held until the occurrence of the next
higher average value.
IEC/IEEE-bus commands
:CALCulate:MARKer:FUNCtion:SUMM:RMS ON
:CALCulate:MARKer:FUNCtion:SUMM:RMS:RES?
:CALCulate:MARKer:FUNCtion:SUMM:RMS:AVER:RES?
:CALCulate:MARKer:FUNCtion:SUMM:RMS:PHOL:RES?
The MEAN softkey selects the measurement of the average value of the signal per
sweep.
Thus, the mean power can be measured, for example during a GSM burst.
In case of maximum peak evaluation, the highest average value since the
activation of PEAK HOLD ON is displayed.
In case of AVERAGE ON, the average values of a trace are averaged and
displayed over several sweeps.
The number of sweeps is set with the SWEEP COUNT softkey. If PEAK HOLD =
ON is active at the same time, the display is held until the occurrence of the next
higher average value.
IEC/IEEE-bus commands :
:CALCulate:MARKer:FUNCtion:SUMM:MEAN ON
:CALCulate:MARKer:FUNCtion:SUMM:MEAN:RES?
:CALCulate:MARKer:FUNCtion:SUMM:MEAN:AVER:RES?
:CALCulate:MARKer:FUNCtion:SUMM:MEAN:PHOL:RES?
1088.7531.12 4.209 E-15