Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Receiver - Data Reduction and Peak List
INTER
ACTIVE
The INTERACTIVE softkey selects the following sequence for the final
measurement:
• A frequency from the frequency list is set on the receiver together with
the associated settings from the corresponding partial scan.
• The marker is set on this frequency in the scan diagram.
• The final measurement sequence switches to the Interrupted status.
• The signal can be exactly analyzed by modifying the receiver settings.
• CONTINUE AT HOLD starts the actual final measurement, the receiver
settings being restored except the frequency.
• The current frequency replaces the original one in the frequency list
(drifting interference sources)
• Next frequency of frequency list.....
Note:
With the AUTOMATIC FINAL softkey in the CONTINUE FINAL
MEAS submenu a switchover can be made to the automatic
mode before the measurement is started anew.
IEC/IEEE-bus command --
RUN
FINAL MEAS
HOLD
FINAL MEAS
HOLD
FINAL MEAS
STOP
FINAL MEAS
The RUN FINAL MEAS softkey starts the final measurement
sequence as described above. The HOLD FINAL MEAS
submenu is called.
The detectors used for the final measurement replace those
used in the list or for the prescan.
The out-of-limit condition is shown by a plus sign preceding the
values in the DELTA LIMIT column (see table below).
IEC/IEEE-bus command --
Note:
The final measurement function is only available in the
manual mode. For operation under program control it
is preferable to read the prescan results and the datareduced
peak list, if any, from the ESIB with the
controller and carry out the individual measurements
with the controller. This considerably makes the
control of the interactive mode easier.
1088.7531.12 4.105 E-15