Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
CALCulate Subsystem
:CALCulate:MARKer:COUNt:RESolution 0.1 | 1 | 10 | 100 | 1000 | 10000 Hz
This command specifies the resolution of the frequency counter.
Example: ":CALC:MARK:COUN:RES 1kHz"
Features: *RST value: 1kHz
SCPI: device-specific
Mode:
A
The numeric suffix in MARKer is not significant.
:CALCulate:MARKer:COUNt:FREQuency?
This command queries the result of the frequency counter.
Example: ":CALC:MARK:COUN:FREQ?"
Features: *RST value: -
SCPI: device-specific
Mode:
A
This command is only a query and thus has no *RST value.
:CALCulate:MARKer:COUPled[:STATe] ON | OFF
This command switches the coupling of markers on or off.
Example: ":CALC:MARK:COUP ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
R, VA
The numeric suffix in MARKer is not significant.
:CALCulate:MARKer:SCOupled[:STATe] ON | OFF
This command switches the coupling of the receiver frequency at the marker frequency on or off.
Example:
":CALC:MARK:SCO ON"
Features: *RST value: ON
SCPI: device-specific
Mode:
R
The numeric suffix in MARKer is not significant.
:CALCulate:MARKer:LOEXclude ON | OFF
This command switches the local oscillator suppression on or off.
Example: ":CALC:MARK:LOEX ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
A-F
The numeric suffixes 1|2 and 1 to 4 are not significant.
1088.7531.12 6.35 E-15