Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
SENSe:FREQuency Subsystem
The SENSe:FREQuency subsystem defines the frequency axis of the active display. The frequency axis
can either be defined via the start/stop frequency or via the center frequency and span.
COMMAND PARAMETERS UNIT COMMENT
[SENSe]
:FREQuency
:CENTer
:LINK
:STEP
:LINK
:FACTor
:SPAN
:FULL
:LINK
:STARt
:LINK
:STOP
:LINK
:MODE
:OFFSet
:CW:
:STEP
:FIXed
:STEP
STARt | STOP | SPAN
SPAN | RBW | OFF
--
CENTer | STARt | STOP
CENTer | STOP | SPAN
CENTer | STARt |SPAN
CW | FIXed | SWEep
HZ
--
HZ
--
PCT
HZ
--
--
HZ
--
HZ
--
--
HZ
HZ
HZ
HZ
HZ
:[SENSe:]FREQuency:CENTer 0 GHz to f max
This command defines the receiver frequency ot the center frequency of the analyzer.
Example: ":FREQ:CENT 100MHz"
Features: *RST value: f max / 2
SCPI: conforming
Modes:
R, A, VA
In the analyzer mode, the automatic coupling of the parameters is set to SPAN FIXED.
:[SENSe:]FREQuency:CENTer:LINK STARt | STOP | SPAN
This command defines the coupling of the center frequency to the start, stop frequency or the
frequency span.
Example: ":FREQ:CENT:LINK STAR"
Features: *RST value: SPAN
SCPI: device-specific
Mode:
A
1088.7531.12 6.133 E-15