Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Example - Level and Frequency Measurement
DATA ENTRY
3
0
dBm
mV MHz
ms
STOP FREQUENCY
30 MHz
½ Press 3 + 0 on the numeric keypad and terminate
the entry by pressing MHz.
The new value for the stop frequency is entered in
the table.
Input 2 should now be selected.
SCAN
RANGES
½ Press the SCAN RANGES softkey.
The SCAN RANGES table is activated and the set
start frequency is marked in the RANGE 1 column.
DATA VARIATION
½ Press the DOWN cursor in the DATA VARIATION
field repeatedly until the INPUT line is marked.
DATA ENTRY
INPUT
dBm
mV MHz
INPUT 1
ms
INPUT 2
½ Press one of the unit keys, eg MHz.
The input selection table is opened.
DATA VARIATION
½ Press the DOWN cursor key in the DATA
VARIATION field.
INPUT 2 is marked.
DATA ENTRY
dBm
mV MHz
ms
½ Press one of the unit keys, eg MHz.
The selection table is closed and INPUT 2 is
displayed in the SCAN RANGES table.
Only one scan range is defined in the example. For
this reason the second subrange (column
RANGE 2) should be cleared.
DATA VARIATION
½ Press the RIGHT cursor key in the DATA
VARIATION field.
An entry in the RANGE 2 column is marked.
1088.7531.12 2.5 E-3