Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Display and Limit Lines - Analyzer
ESIB
TIME
LINE 1
TIME
LINE 2
The TIME LINE 1/2 softkeys switch the time lines 1/2 on/off and activate the
entry of line locations.
The time lines mark the selected times or define the search range (see
section "Marker Functions").
IEC/IEEE-bus commands
:CALCulate:TLINe:STATe ON | OFF;
:CALCulate:TLINe 10ms
BASELINE
CLIPPING
The BASELINE CLIPPING softkey switches on or off the BASELINE
CLIPPING function and allows a limit value to be entered.
The BASELINE CLIPPING function is for blanking measured values (for
example noise) which are below a preset threshold.
If the BASELINE CLIPPING function is active and a measured value is below
the preset threshold, the value is set to a lower boundary (-400 dBm).
Measured values above the clipping level are not changed.
Note:
It is advisable not to combine the BASELINE CLIPPING function
with the AUTOPEAK detector.
If the set clipping value is within the displayed noise band
(AUTOPEAK detector), activation of the CLIPPING function and
the resulting clipping of the MIN PEAK values will lead to a drastic
enlargement of the displayed noise band.
IEC/IEEE-bus commands
:CALCulate:CTHReshold:STATe ON | OFF
:CALCulate:CTHReshold -82dBm
1088.7531.12 4.216 E-15