Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Instrument Status and Measurement Parameters
Hardware Configuration and Options
SYSTEM INFO menu:
HARDWARE+
OPTION
The HARDWARE+OPTIONS softkey opens two tables in which the modules
(INSTALLED COMPONENTS) installed in the instrument are listed.
• Table MODEL lists the instrument name and model:
ESIB26
MODEL
• Table INSTALLED COMPONENTS consists of four columns:
COMPONENT name of module
MODEL INDEX model number of the module
MODIF INDEX main modification index of the module
HW CODE secondary modification index of the module
These lists contain only the modules which are actually present in the
instrument, i.e., the modules which were identified by the module
recognition software.
INSTALLED COMPONENTS
COMPONENT MODEL INDEX MODIF INDEX HW CODE
Main Processor 4 n/a 0
Graphic Board 4 n/a 0
I/O Board 4 n/a 0
FRAC SYN 4 0 4
RF Module 4 0 4
2nd IF Converter 3 2 2
LO Phase 3 4 12
Preselector 2 6 0
MW Converter 2 0 0
MW YIG Filter 2 0 0
Detector 4 0 2
RF Attenuator 4 4 0
IF Filter 3 2 3
Digital IF 2 0 2
IEC/IEEE- bus command
*OPT?
:SYSTem:BINFo?
OPTIONS
The OPTIONS softkey opens two tables listing the options installed. The
standard ESIB is equipped with options FSE-B4 and FSE-B5. The options are
indicated for reasons of compatibility to instrument family FSE.
DESIGNATION
FFT
FIRMWARE OPTIONS
TYPE
B5
CODE
1938496289
Note: New firmware options can be enabled in the SETUP menu.
DESIGNATION
HARDWARE OPTIONS
CODE
Low Phase Noise & OCXO
Vector Signal Analysis
B4
B7
IEC/IEEE- bus command
*OPT?
1088.7531.12 4.15 E-15