Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Receiver - Operation on a Discrete Frequency
Setting the RF Attenuation
ESIB is equipped with two signal inputs selectable in the INPUT menu. With INPUT 1 selected the RF
attenuation can be set between 0 and 70 dB in 10 dB steps. With INPUT 2 - this is the pulse-resistant
input - the attenuation can be set between 0 and 70 dB in 5 dB steps.
CONFIGURATION MODE - EMI RECEIVER menu
ATTEN
ATTEN
ATTEN
MANUAL
0 DB MIN
ON OFF
AUTO RANGE
ON OFF
AUTOPREAMP
ON OFF
The ATTEN softkey opens a submenu where the input
attenuator can be configured. The submenu includes setting
the RF attenuation and the autorange function.
ATTEN
MANUAL
The RF ATTEN MANUAL softkey activates the attenuation
entry field.
The following attenuation can be set depending on the active
input:
• INPUT 1: 0 to 70 dB in 10 dB steps,
• INPUT 2: 0 to 70 dB in 5 dB steps..
Other entries are rounded to the next higher integer.
IEC/IEEE-bus command
:INPut:ATTenuation
1088.7531.12 4.77 E-15