Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

SENSe Subsystem
ESIB
:[SENSe:]SCAN:BANDwidth:RESolution f min to f max
This command defines the bandwidth for a receiver subscan.
Example: ":SCAN1:BAND:RES 1MHz"
Features: *RST value: 9 kHz (range 1)
120 kHz (range 2)
SCPI: device-specific
Mode:
R
:[SENSe:]SCAN:TIME 100 µs to 100 s
This command defines the measurement time of the receiver subscan.
Example: ":SCAN1:TIME 1 ms"
Features: *RST value: 1 ms (range 1)
100µs (range 2)
SCPI: device-specific
Mode:
R
:[SENSe:]SCAN:INPut:TYPE INPUT1 | INPUT2
This command defines the input for a receiver subscan.
Example: ":SCAN1:INP:TYPE INPUT2"
Features: *RST value: INPUT1
SCPI: device-specific
Mode:
R
:[SENSe:]SCAN:INPut:ATTenuation dB min to dB max
This command defines the RF attenuation for a receiver subscan.
Example: ":SCAN1:INP:ATT 30dB"
Features: *RST value: 10 dB
SCPI: device-specific
Mode:
R
:[SENSe:]SCAN:INPut:ATTenuation:AUTO ON | OFF
This command switches on or off the autoranging function in a receiver subscan.
Example: ":SCAN1:INP:ATT:AUTO ON"
Features: *RST value: OFF
SCPI: device-specific
Mode:
R
1088.7531.12 6.148 E-15