Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

MarkerÅ Menu - Analyzer
ESIB
MKR->
REF LEVEL
The MKR→REF LEVEL softkey sets the reference level to that of the current
marker.
IEC/IEEE-bus command
:CALCulate:MARKer:FUNCtion:REFerence
MKR->CF
STEPSIZE
The MKR→CF STEPSIZE softkey sets the step size for the center frequency
variation to the current marker frequency, and also sets step-size adaptation
to MANUAL. The CF STEP SIZE remains at this value until the center
frequency entry mode in the STEP menu is switched from MANUAL to AUTO
again.
The MKR→CF STEPSIZE function is, above all, useful when measuring
harmonics with a large dynamic range (small bandwidth and small span).
The softkey is not available in the time domain.
IEC/IEEE-bus command
:CALCulate:MARKer:FUNCtion:CSTep
MKR->
START
The MKR→START softkey sets the start frequency to the current marker
frequency.
The softkey is not available in the time domain.
IEC/IEEE-bus command
:CALCulate:MARKer:FUNCtion:STARt
MKR->
STOP
The MKR→STOP softkey sets the stop frequency to the current marker
frequency.
The softkey is not available in the time domain.
IEC/IEEE-bus command
:CALCulate:MARKer:FUNCtion:STOP
MKR->
TRACE
The MKR→TRACE softkey places the active marker on a new trace. The
traces available for selection appear in the selection window.
SELECT TRACE
TRACE1
TRACE2
TRACE3
TRACE4
IEC/IEEE-bus commands
:CALCulate:MARKer:TRACe 2
:CALCulate:DELTamarker:TRACe 2
1088.7531.12 4.212 E-15