Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Sweep Control - Analyzer
ESIB
Operation steps on the ESIB:
[PRESET]
[MODE]
[↑]
ANALYZER
[CENTER: {802} MHz]
[SPAN
{3.6} MHz]
[REF LVL: {0} dBm: RF ATTEN MANUAL: {10} dB]
[COUPLING: RES BW MANUAL: {30} kHz]
[TRACE 1: DETECTOR: RMS]
[SWEEP:
SWEEPTIME MANUAL: {50} ms;
GATE ON
GATE SETTINGS: GATE MODE EDGE: GATE POL POS: GATE RF POWER
GATE ADJUST: SWEEPTIME MANUAL {1} ms: GATE DELAY {300} µs:
GATE LENGTH: {250} µs]
Note: [KEY] Menu called by the KEY. All indications inside the bracket refer to this menu.
{Number} Numeric value to be entered for the corresponding parameter
SOFTKEY Softkey used to select a parameter or enter a value.
The following figure shows the screen display for gate parameter setting: The vertical lines for gate
delay (GL) and gate length (GL) can be adapted to the burst signal by entering numbers or with the
rollkey.
Fig. 4-16
Setting the GATE DELAY and GATE LENGTH times in the time domain using the GD
and GL lines
On quitting the menu GATE ADJUST, the ESIB returns to spectral representation.
1088.7531.12 4.258 E-15