Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

CALibration Subsystem
ESIB
:CALibration:LDETector?
This command performs a calibration of the log module’s characteristic and of the detectors. A "0" is
returned if the calibration was successful.
Example: ":CAL:LDET?"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A, VA
:CALibration:LOSuppression?
This command performs a calibration of the local oscillator suppression. . A "0" is returned if the
calibration was successful.
Example: ":CAL:LOS?"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A, VA
:CALibration:PPEak?
This command performs a calibration of the tracking YIG filter (preselector peaking). A "0" is
returned if the calibration was successful.
Example: ":CAL:PPE?"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A
:CALibration:PRESelector?
This command performs a calibration of the preselector. If this is done successfully, "0" is returned.
Example: ":CAL:PRES?"
Characteristics: *RST value: -
SCPI: device-specific
Modes:
R
:CALibration:SHORt?
This command performs a short calibration. A "0" is returned if the calibration was successful.
Example: ":CAL:SHOR?"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A, VA
:CALibration:STATe ON | OFF
This command determines whether (ON) or not (OFF) the current calibration data are taken into
consideration.
Example: ":CAL:STAT OFF"
Features: *RST value: -
SCPI: conforming
Modes:
R, A, VA
1088.7531.12 6.60 E-15