Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
SENSe Subsystem
:[SENSe:]CORRection:TRANsducer:DELete
This command deletes the selected transducer factor.
Example: ":CORR:TRAN:DEL"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A
This command is an event and therefore has no *RST value.
Prior to this command, the command SENS:CORR:TRAN:SEL must be sent.
:[SENSe:]CORRection:TSET:CATalog?
This command polls the names of all transducer factors stored on the harddisk.
Syntax of output format:
,,
,,,,,,....,,
Example: ":CORR:TSET:CAT?"
Mode:
R, A
Feature: *RST value: -
SCPI: device-specific
:[SENSe:]CORRection:TSET:ACTive?
This command reveals the active transducer set. If no transducer set is switched on, a void string will
be output.
Example: ":CORR:TSET:ACT?"
Feature: *RST value: -
SCPI: device-specific
Mode:
R, A
:[SENSe:]CORRection:TSET:SELect
This command selected the transducer set designated by . If does not exist yet, a
new set is created.
Parameter: ::= name of the transducer set in string data form with a maximum
of 8 characters.
Example: ":CORR:TSET:SEL ’SET1’"
Features: *RST value: -
SCPI: device-specific
Modes:
R, A
This command must be sent prior to the subsequent commands for changing/activating the
transducer sets.
1088.7531.12 6.113 E-15