Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Configuration/Setup
EDIT TRD
FACTOR
NEW TRD
FACTOR/SET
The EDIT TRD FACTOR and NEW FACT/SET softkeys
both open the submenu for editing and entering new
transducer factors. A precondition for the NEW
FACTOR/SET softkey is that the selection bar is located
in the table when the table TRANSDUCER FACTOR is
called up.
EDIT TRANSDUCER FACTOR
Name:
Antenna1
Unit:
dBuV/m
Interpolation: LIN
Comment: Ant1 and cable 1
NO.
FREQUENCY TDF/dB.. FREQUENCY
20.0000 MHz
25.0000 MHz
30.0000 MHz
40.0000 MHz
50.0000 MHz
60.0000 MHz
70.0000 MHz
80.0000 MHz
25.5
23.8
20.5
19.8
20.0
19.5
19.1
18.2
TDF/dB..
EDIT TRD
FACTOR
TRD FACTOR
NAME
TRD FACTOR
UNIT
TRD FACTOR
VALUES
INSERT
LINE
DELETE
LINE
USER
SAVE TRD
FACTOR
DRAW TRD
FACTOR
24
25
48
49
50
The table with the data of the marked factor (the EDIT TRD FACTOR softkey) or an empty table is
displayed in which the following entries are preset (the NEW FACTOR/SET softkey):
Unit:
dB
Interpolation: LIN for linear frequency scaling
LOG for logarithmic frequency scaling
The characteristics of the factor can be entered in the header field of the table, the frequency and the
transducer factor in the columns of the table.
Name
Entry of the name
Unit
Selection of unit
Interpolation Selection of interpolation
Comment Entry of a comment
FREQUENCY Entry of the frequency of the reference points
TDF/dB Entry of the transducer factor.
An overwritten transducer factor remains stored in the background as long as the edited factor is stored
with the SAVE TRD FACTOR softkey or until the table is closed. A factor overwritten by mistake can be
restored by leaving the entry.
1088.7531.12 4.25 E-15