Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Screen
Full Screen
In the full-screen mode,, the settings and measurements are performed in the active visible window. All
indications on the screen refer to this window. The designation (SCREEN A or SCREEN B) is inserted
as enhancement label A or B on the right diagram margin.
The DISPLAY key is used to switch between the windows. The current measurement is terminated
when its window goes blank.
Switching from split-screen to full-screen mode is performed in menu SYSTEM DISPLAY.
Split Screen
In the Split Screen mode, the screen is divided into two halves.
USER
-20.0
-40.0
Ref Lvl
-20 dBm
Marker 1 [T1 CNT]
-36.42 dBm
100.002 MHz
RBW
VBW
SWT
1 MHz
1 MHz
5 ms
RF Att 20 dB
Mixer -40 dBm
Unit dBm
A
SOFTKEY 1
-60.0
SOFTKEY 2
-80.0
-100.0
-120.0
-20.0
-40.0
-60.0
-80.0
-100.0
Center 100.0 MHz 5 MHz/ Span 50.0 MHz
Ref Lvl
-20 dBm
Marker 1 [T1 CNT]
-36.42 dBm
100.002 MHz
RBW
VBW
SWT
1 MHz
1 MHz
5 ms
RF Att 20 dB
Mixer -40 dBm
Unit dBm
SOFTKEY 3
SOFTKEY 4
SOFTKEY 5
SOFTKEY 6
SOFTKEY 7
SOFTKEY 8
SOFTKEY 9
-120.0
Center 100.0 MHz 5 MHz/ Span 50.0 MHz
SOFTKEY 10
Fig. 3-4
Split Screen mode
In the default receiver mode, the screen is divided up according to fixed configurations.
Table 3-1 Default assignment of traces to windows with split screen in the receiver mode
upper (screen A) Indication of level and frequency Zoomed scan
lower (screen B) Scan spectrum Scan spectrum
However, a selection can be made in the upper half of the screen (SCREEN A) between bargraph
display of the receiver mode and the spectrum analyzer mode.
With spectrum analyzer selected, the scan display in the lower half of the screen remains unchanged
and the spectrum analyzer with all its measurement functions is available in the upper screen half (see
Chapter 4, Section ’Display Configuration’).
1088.7531.12 3.9 E-13