Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Recalling Data Sets
Selecting the Data Set for Recalling
MEMORY RECALL menu:
EDIT
NAME
The EDIT NAME softkey activates the entry of a data set name.
The data input is terminated by pressing one of the units keys which
simultaneously initiates the data set recall operation.
IEC/IEEE-bus command :MMEMory:LOAD:STATe 1,’A:test’
EDIT
PATH
The EDIT PATH softkey activates the entry of a directory name in which the
data set is located. Default path is c:\user\config.
IEC/IEEE-bus command --
AUTO
RECALL
The AUTO RECALL softkey activates the selection of a data set which will be
automatically recalled when the instrument is powered up. The DATA SET
LIST/CONTENT table is opened to make the selection (analogous to DATA
SET LIST).
IEC/IEEE-bus command
:MMEMory:LOAD:AUTO 1,’C:\user\data\auto’
DATA SET LIST
DATASET1
DATASET2
DATASET3
AUTO RECALL SET CONTENT
CONTENTS
GENERAL SETUP
HW-SETTINGS
TRACE 1
TRACE 2
TRACE 3
TRACE 4
LINES
CVL TABLES
COLOR SETUP
HARDCOPY
MACROS
TRANSDUCER
COMMENT
GSM_MASK
The DATA SET LIST column displays all the data sets in the selected
directory.
The CONTENTS and COMMENT lines in the AUTO RECALL CONTENTS
column indicate the saved data subsets and the comments for the currently
selected data set.
In addition to the data sets saved by the user, the data set FACTORY, which
contains the settings of the instrument before it was last switched off
(Standby), is always included.
If a data set other than FACTORY is chosen the data subsets in the selected
data set that are available are recalled when the ESIB is powered up. The
data subsets which are not in this data set are taken from the FACTORY data
set.
Note:
The selected data set is also loaded on PRESET if AUTO RECALL
is active. The preset settings can then be configured as required.
1088.7531.12 4.67 E-15