Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

CALCulate Subsystem
ESIB
:CALCulate:LIMit:UPPer:SPACing LINear | LOGarithmic
This command makes a selection between linear and logarithmic interpolation for the upper limit line.
Example: ":CALC:LIM:UPP:SPAC LIN"
Features: *RST value: LIN
SCPI: device-specific
Modes:
R, A, VA
:CALCulate:LIMit:LOWer[:DATA] ,..
This command defines the values for the selected lower limit line.
Example: ":CALC:LIM:LOW -30,-40,-40,-30"
Features: *RST value: - (LIMit:STATe is set to OFF)
SCPI: conforming
Modes:
R, A, VA
The number of values for the CONTrol axis and the corresponding LOWer limit line have to be
identical.If the measured values violate the LOWer limit line in analyzer or vector analyzer mode, the
limit check signals errors. The unit must be identical with the unit selected by CALC:LIM:UNIT.
The units DEG, RAD, S, and HZ are available in the vector signal analysis mode only.
:CALCulate:LIMit:LOWer:STATe ON | OFF
This command defines the selected limit line as lower limit line.
Example: ":CALC:LIM:LOWer:STAT ON"
Features: *RST value: OFF
SCPI: conforming
Modes:
R, A, VA
In analyzer and vector analyzer mode, the result of the limit check can be queried with
CALCulate:LIMit:FAIL?.
:CALCulate:LIMit:LOWer:OFFSet
This command defines an offset for the Y-axis of the selected relative lower limit line.
Example: ":CALC:LIM:LOW:OFFS 3dB"
Features: *RST value: 0
SCPI: device-specific
Modes:
A, VA
:CALCulate:LIMit:LOWer:MARGin
This command defines the margin of the selected lower limit line.
Example: ":CALC:LIM:LOW:MARG 10dB"
Features: *RST value: 0
SCPI: device-specific
Modes:
A, VA
1088.7531.12 6.26 E-15