Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

ESIB
Receiver - Automatic Control of Line Impedance Stabilization Networks
Automatic Control of Line Impedance Stabilization Networks
The selected phases are controlled during the prescan and the final measurement via the USERPORT
with the LISN switched on. In contrast, the LISN menu in the SETUP menu is used for the direct control
of the LISN and is not included in the automatic sequences.
Only one phase and one PE setting (1 out of n) can be selected for the prescan. Any number of settings
can be selected for the final measurement (m out of n).
All selected phase/PE combinations are measured during the final measurement and the maximum
value is determined.
CONFIGURATION MODE - EMI RECEIVER menu (right side menu)
LISN
LISN
ESH2-Z5
ENV 4200
The LISN softkey opens the submenu for
automatic control of V-networks (LISNs)
ESH3-Z5
OFF
PRESCAN
PHASES
FINAL
PHASES
PRESCAN/FINAL
PHASES
PHASE N
PHASE L1
PHASE L2
PHASE L3
PE
GROUNDED
PE
FLOATING
ESH2-Z5
ENV 4200
ESH3-Z5
Softkeys ESH2-Z5/ENV 4200, ESH3-Z5 and OFF allow to select
the V-network to be controlled via the user port.
ESH2-Z5/ENV 4200
ESH3-Z5
OFF
four-line V-network is controlled,
two-line V-network is controlled,
remote control is deactivated.
IEC/IEEE-bus command
:INPut:LISN[:TYPE] TWOPhase| FOURphase| OFF
OFF
1088.7531.12 4.109 E-15