Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

STATus Subsystem
ESIB
:STATus:QUEStionable:TRANsducer:ENABle 0 to 65535
This command sets the bits of the ENABle section of the :STATus:QUEStionable:TRANsducer
register.
Example: ":STAT:QUES:TRAN:ENAB 65535"
Features: *RST value: –
SCPI: device-specific
Modes:
R, A, VA
The ENABle register selectively enables the individual events of the associated EVENt section for the
sum bit in the status byte.
:STATus:QUEStionable:TRANsducer:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the :STATus:QUEStionable:TRANsducer
register from 0 to 1 for the transitions of the CONDition bit.
Example: ":STAT:QUES:TRAN:PTR 65535"
Features: *RST value: –
SCPI: device-specific
Modes:
R, A, VA
:STATus:QUEStionable:TRANsducer:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the :STATus:QUEStionable:TRANsducer
register from 1 to 0 for the transitions of the CONDition bit.
Example: ":STAT:QUES:TRAN:NTR 65535"
Features: *RST value: –
SCPI: device-specific
Modes:
R, A, VA
:STATus:QUEue[:NEXT]?
This command queries the earliest entry to the error queue, thus deleting it.
Example: ":STAT:QUE?"
Features: *RST value: –
SCPI: conforming
Modes:
R, A, VA
Positive error numbers indicate device-specific errors, negative error numbers are error messages
defined by SCPI (cf. Chapter 9). If the error queue is empty, the error number 0, "no error", is
returned. This command is identical with the command SYSTem:ERRor.
1088.7531.12 6.166 E-15