Operating Manual EMI TEST RECEIVER ESIB7 - Rohde & Schwarz

Manual Control
ESIB
Status Display-Remote/Manual Control – STATUS Key
Group
STATUS
SRQ
REMOTE
LOCAL
The SRQ LED, the REMOTE LED and the LOCAL. key are contained in the
STATUS key group.
é
é
é
The SRQ LED indicates that a service request from the instrument has
been asserted on the IEC Bus.
The REMOTE LED indicates that the instrument is under remote control.
The LOCAL key switches the instrument from remote to manual control,
with the assumption that the remote controller has not previously set the
LOCAL LOCKOUT function.
A change in the control mode comprises:
- Enabling the Front Panel Keys
Under remote control, the softkey menu is turned off and all keys, with
the exception of PRESET and LOCAL, are disabled. Returning to
manual mode enables all disabled keys. The main menu of the current
mode is selected as the softkey menu..
- Turning off the REMOTE LED
- Generating the message OPERATION COMPLETE
If the synchronization via *OPC, *OPC? or *WAI is active when the
LOCAL softkey is pressed, any measurement procedure that is running
is aborted and synchronization is achieved by setting the corresponding
bits in the registers of the status reporting system.
- Setting Bit 6 (User Request) of the Event Status Register
If the status reporting system is configured appropriately, setting this bit
immediately elicits a service request (SRQ) which is used to inform the
controller that the user wishes to return to front-panel control. This
information can be used, e.g., to interrupt the control program so that the
user can make the necessary manual corrections to instrument settings.
This bit is set each time the LOCAL key is pressed.
é The LOCAL key aborts a running macro. The continuation of the macro is
not possible.
IEC/IEEE-bus command
CALL IBLOC(receiver%)
1065.6016.12 4.48 E-15