Regional Basic Professional Training Course in Korea

systems and components.
❙ 431 ❙
7. Quality Assurance
3. Identification and control of design interfaces and for coordination among
participating design organizations, including the establishment of procedures
among participating design organizations for the review, approval, release,
distribution, and revision of documents involving design interfaces.
(2) Enterpriser shall take measures for design control such as checking of the adequacy of
a design by such means as a design review, calculations or testing, and such measures
shall include each of the following:
1. Reactor physics, stress, thermal, hydraulic, and accident analyses
2. Compatibility of materials and accessibility for inservice inspection, maintenance,
and repair
3. Verification or checking of the adequacy of a design by a third party; and
4. Delineation of acceptance criteria for inspections and tests.
(3) Where a test program is used to verify the adequacy of a specific design feature in lieu
of other verifying or checking processes, it shall include suitable qualifications testing
of a prototype unit under the most adverse design conditions.
(4) Design changes, including field changes, shall be subject to design control measures
commensurate with those applied to the original design as provided in the foregoing
Paragraphs (1) and (2) and be approved by the organization that performed the
original design unless the enterpriser designates another responsible organization.
❱ Article 71 (Procurement Document Control)
(1) Enterpriser shall establish measures to assure that applicable regulatory requirements,
design bases, and other requirements which are necessary to assure adequate quality
are suitably included or referenced in the documents for procurement of material,