Microsoft Sharepoint Products and Technologies Resource Kit eBook

Chapter 12: Deploying Medium and Large Server Farms 291
19. On the Port Rules tab, in the Filtering mode section, verify that multiple
host is enabled and that Portal Server is set to None, as shown in Figure 12-4.
F12XR04
Figure 12-4 Set NLB Port Rules on SPS-01
To configure additional front-end NICs (SPS-02)
1. In Windows Control Panel, click Network Connections.
2. Right-click Local Area Connection and then click Properties.
3. Under This connection uses the following items, click Internet Protocol
(TCP/IP).
4. Click Properties.
5. Click Use the following IP address, and type in the IP address with your
assigned front-end static IP address. (This is the IP address for the machine, not
the cluster.)
6. Type in the subnet mask associated with this IP address.
7. Type in the default gateway with your assigned front-end gateway.
8. Click Advanced.
9. Under IP address, click Add.
10. In the IP Address box, type the cluster IP address as shown in Figure 12-5.
11. Type in the subnet mask associated with the cluster IP.
12. On the DNS tab, remove all DNS entries.
13. Deselect the Register this connections addresses in DNS box.
14. On the WINS tab, remove all WINS entries.
15. On the LAN Connection Properties page, under This connection uses the
following items, click Network Load Balancing.