DCP Series Telcon Message Manual - Public Support Login - Unisys

1010 HOSTSRV OUTPUT HIC ANALYSIS ERROR
Event 12 TCP–IP GATEWAY EVENT
Description: The header received had an invalid HIC sequence. An error message is
created and sent to the ULP. The host services module for the TCP–IP Stack program
product generates this CENLOG.
1011 HOSTSRV ERROR CODE FROM INCOMING MESSAGE
Description: A message was received from the LLP with the message type of
ERROR. The host services module for the TCP–IP Stack program product generates
this CENLOG.
1012 HOSTSRV NO SOURCE IP ADDRESS CONFIGURED
Description: The TSID/PROCID combination was not found in the source address
table; the search is done to obtain the source IP address. (The source address table is
built from the HOSTID entries on the EU card.) This error causes the current session
to terminate. The host services module for the TCP–IP Stack program product
generates this CENLOG.
1021 HOSTSRV UNEXPECTED DCA INPUT
Description: A DCA control message was received that was not correct at this point
of the processing sequence. The following information should be recorded and given
to the site analyst:
R12: Return address — contents of R7 before CENLOG call
The host services module for the TCP–IP Stack program product generates this
CENLOG.
1022 HOSTSRV NO DCA$ ENTRY AVAILABLE
Description: A new connection table entry could not be created either because the
maximum number of TCP connections was reached or no segments were available for
connection tables. The maximum number of TCP connections is a configurable value
(TCPP). This condition is usually temporary. This error causes the current session to
terminate. The host services module for the TCP–IP Stack program product generates
this CENLOG.
1023 HOSTSRV BAD DCA CC PACKET
Description: A bad DCA connect confirm message was received. The host services
module for the TCP–IP Stack program product generates this CENLOG.
7436 0728–303 3–63